Features And Controls - Sears Craftsman C950-52951-0 Owner's Manual

A
C
B
Snowthrower Controls
SNOWTHROWER CONTROLS
A. Speed Select Lever — Allows the operator to use one of six (6) forward
and two (2) reverse speeds (see Figure 9). To shift, move speed select lever to
desired position.
NOTICE: Do not move speed select lever while Traction
Control is engaged. This may result in severe damage
to the drive system.
B. Auger Control Lever — Used to engage and disengage the auger and
impeller. To engage push down, to disengage release.
C. Chute Rotation Switch — Used to rotate the discharge chute to the left or
right.
D. Deflector Control Lever — Used to control the angle of the chute
deflector (up or down).
J
D
G
SNOWTHROWER AND ENGINE CONTROLS

FEATURES AND CONTROLS

F
E
I
TM Control — After engaging the traction control (left hand) and
E. Free-Hand
auger control (right hand), allows the operator to release the auger control
lever to use the other controls.
F. Traction Control Lever — Used to propel snowthrower forward or reverse.
Push down to engage, release to disengage.
G. Skid Shoe — Used to adjust the ground clearance of the auger
housing.
H. Clean-Out Tool — Used to remove snow and debris from the discharge
chute and the auger housing.
I. Headlight — Used to operate the snowthrower in poor lighting conditions.
J. Grip Warmer Switch — Used to warm the hand grips (high or low).
1 2
H
Figure 9
19