Ice Chute Extension - Electrolux EI23CS55GS1 Use & Care Manual

Care and cleaning tips
Part Cleaning Agents
Interior & Door • Soap and water
Liners • Baking soda and
water
Door Gaskets • Soap and water
Drawers & Bins • Soap and water
Glass Shelves • Soap and water
• Glass cleaner
• Mild liquid
sprays
Toe Grille • Soap and water
• Mild liquid
sprays
• Vacuum
Exterior & • Soap and water
Handles
• Non abrasive
glass cleaner
Exterior & • Soap and water
Handles
(Stainless Steel • Stainless steel
Models Only) cleaners

Ice Chute Extension

The ice chute extension is
designed to better direct
ice flow into containers.
Removing the Ice Chute Extension For
Cleaning
1 Turn the refrigerator off
using the button on the
control panel (refer to
Owner's Manual).
2 Press inward firmly on
the front of the chute
and pull down.
3 Turn your refrigerator
back on.
Tips and Precautions
• Use two tablespoons of baking soda in one quart of warm water.
• Be sure to wring excess water out of sponge or cloth before cleaning around controls, light
bulb or any electrical part.
• Wipe gaskets with a clean soft cloth.
• Use a soft cloth to clean drawer runners and tracks.
• Do not wash any removable items (bins, drawers, etc.) in dishwasher.
• Allow glass to warm to room temperature before immersing in warm water.
• Remove toe grille (see Installation Instructions).
• Vacuum both sides and wipe with sudsy cloth or sponge. Rinse and dry.
• Do not use commercial household cleaners containing ammonia, bleach or alcohol to clean
handles.
• Use a soft cloth to clean smooth handles.
• Do not use a dry cloth to clean smooth doors.
• Never use CHLORIDE or cleaners with bleach to clean stainless steel.
• Clean stainless steel front and handles with non-abrasive soapy water and a dishcloth.
Rinse with clean water and a soft cloth.
• Use a non-abrasive stainless steel cleaner. These cleaners can be purchased at most home
improvement or major department stores. Always follow manufacturer's instruction. Do not
use household cleaners containing ammonia or bleach.
• NOTE: Always clean, wipe and dry with grain to prevent scratching.
• Wash the rest of the cabinet with warm water and mild liquid detergent. Rinse well and
wipe dry with a clean soft cloth.
Press Here
Firmly
Pull Down
Care and Cleaning
Installing the Ice Chute Extension
1 Turn the refrigerator
off using the button
on the control panel
(refer to Owner's
Manual).
2 Align the extension
with the ice chute so
that the snap clips are
just inside the front
edge of the chute.
3 Push upward until the
extension snaps into place.
4 Turn your refrigerator back on.
29
Push Upward Until The
Extension Snaps In Place