Electrolux EI23CS55GS1 Use & Care Manual page 11

NOTE
You will be pulling approximately five (5) feet of water
tube from the back of the refrigerator.
4 Unscrew the three (3) lower hinge screws and
hinge if necessary.
To reinstall the right door, reverse the above steps.
Lower Hinge Removal
Once both doors are in place, ensure they are aligned
with each other and level (Please see the "Installation"
section for more details), and replace the top hinge
cover.
NOTE
When reinserting the water tube and replacing the top
hinge cover, use care to be sure you do not kink the
tube.
CAUTION
Be sure doors are set aside in a secure position
where they cannot fall and cause personal injury,
or damage to the doors or handles.
Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left sides
(two (2) screws on each side).
Remove Hex
Head Drawer
Screw
Do Not Remove
Other Screws
Remove
Hex Head
Drawer
Screw
NOTE
Do not remove center screw from freezer drawer. This
is a factory adjustment.
Removing the Doors
NOTE
Support door and hold stationary while removing
screws. Factory adjustment may be affected if door is
allowed to fall forward during screw removal.
3 Lift drawer up and out to remove.
CAUTION
Drawer is heavy. Use caution when lifting.
Installing Freezer Drawer
1 With lower slides and basket pulled out, mount
drawer in reverse of removal.
2 Tighten drawer screws then turn another ¼ turn.
3 Check gasket seal around freezer drawer. Make
adjustments on drawer screws if necessary.
Remove Hex
Head Drawer
Screw
Remove
Hex Head
Drawer
Screw
11