Floor Rear Crossmember
Removal (cont'd)
Construction
NOTE:
This section explains the procedures after removal of all related parts. For the related parts' removal procedure, refer
●
to the appropriate Service Manual.
The component replacement procedure described here is only for new Honda-supplied parts, as needed, according to
●
the area and the degree of damage on the body.
Remove floor rear extension B from one side.
●
Cut the rear edge [A] of the third-seat pan where it wraps over the inner crossmember, and peel it back.
●
Cut the position [B] of the inner crossmember, and drill the six spot welded points [C] on the inner crossmember.
●
Drill the three spot welded points [D] on the outer crossmember from outside of it, and separate the side and the
●
center with the inner crossmember.
Leave the left side of the inner crossmember on the body side, while lowering the left side of the outer crossmember,
●
move the other side diagonally, and remove the floor rear crossmemer as shown.
Replace the crossmember separator of one side.
●
[VIEW: Z]
INNER CROSSMEMBER
[C]
[B]
Cut line
CROSSMEMBER
SEPAREATOR
Reuse.
CROSSMEMBER EXTENSION
Leave on the body side.
OUTER CROSSMEMBER
3-52
[Z]
INNER CROSSMEMBER
[D]
[VIEW: X]
INNER CROSSMEMBER
100 mm (3.94 in)
[X]
CROSSMEMBER
SEPARATOR
Replace.
FLOOR REAR CROSSMEMBER
MOUNTING BOLTS
6 x 1.0 mm
INNER CROSSMEMBER
OUTER CROSSMEMBER
[A]
Cut and peel back.
THIRD-SEAT PAN
RIGHT FLOOR REAR
EXTENSION B
REAR COMBINATION
ADAPTER
MOUNTING BOLTS
6 x 1.0 mm