7. Tack weld the new parts, and check the rear
suspension position.
8. Rough-cut the side sill outer panel repair part and the
rear side outer panel repair part, and clamp them to
the body.
9. Check the body dimensions.
Door hinge positions (see page 4-7)
●
Sliding door female guide and striker positions (see
●
page 4-8)
Passenger's compartment (see page 4-9)
●
Windshield and door openings (see page 4-13)
●
10. Temporarily install the front door and the sliding
door, then check for differences in level and
clearance.
Check the external parts fitting positions (see page
4-15). Make sure the body lines flow smoothly.
NOTE: Check that the sliding door opens and closes
smoothly.
11. From under the floor, weld inside sill B to the floor
frame outrigger (A), the trailing arm outrigger (C), and
the rear wheel arch extension (D).
D
(8)
(1)
L=35
(1.38)
C
A
(3)
(3)
(4)
Front
B
12. Weld side sill B, side sill A, and the side sill stiffener
(C).
C
(Left side only)
B
Front
(2)
13. Weld the middle floor outrigger (A) to inside sill B and
the floor frame (C).
L=42 (1.65)
[Z]
B
[VIEW: Z]
B
Front
(1)
(2)
A
C
A
(3)
Front
A
L=42 (1.65)
C
L=80 (3.14)
(cont'd)
(8)
3-37