18. Plug weld inside sill B to the floor panel (A) and the
second seat plate (C).
(1) L=5 (0.20)
B
B
C
19. Recheck the clearance and alignment of the front door
and the sliding door.
20. Trim the cut and joint areas of the outer panel repair
part as needed, and prepare the butt-welding
connections. Remove the outer panel repair parts.
21. Weld the quarter pillar stiffener extension (A) and the
rear wheel arch extension (B).
B
(1)
(6)
L=5 (0.20)
A
(8)
(7)
(1)
A
(1)
(5)
A
22. Weld the patch (A) at the cut sections of the body side
outer panel (B).
Front pillar and center pillar cut section (see step 9 on
page 3-26)
30 mm (1.18 in)
23. Install the new wheel arch outer separator (A) on the
rear wheel arch extension (B).
NOTE: Apply the sealer (C) all the way around the
separator and inside the outer panel (D) without gaps.
Front pillar outer separator (see step 11 on page
●
3-26)
Center pillar outer separators (see step 10 on page
●
3-26)
B
A
C
(1)
B
B
(8)
A
D
(cont'd)
3-39