Rear Side Outer Panel
Removal (cont'd)
Construction
NOTE:
This section explains the procedures after removal of all related parts. For the related parts' removal procedure, refer
●
to the appropriate Service Manual.
The component replacement procedure described here is only for new Honda-supplied parts, as needed, according to
●
the area and the degree of damage on the body.
Cut and pry off the rear side outer panel, and replace it.
●
NOTE: Select the cutting positions in consideration of the rear side outer panel repair part (see page 1-14).
Check the rear combination adapter for damage. If necessary, replace it.
●
Replace the wheel arch outer separator.
●
OUTER PANEL
QUARTER
INNER PILLAR
REAR WHEEL
ARCH EXTENSION
OUTER PANEL
3-46
QUARTER INNER
PILLAR
[Z]
REAR INNER
PANEL
REAR WHEEL ARCH
OUTER SEPARATOR
[VIEW: Z]
MOUNTING BOLTS
MOUNTING BOLTS
8 x 1.25 mm
8 x 1.25 mm
REAR PILLAR
STIFFENER
OUTER PANEL
REAR PILLAR GUTTER
REAR PILLAR
STIFFENER
REAR COMBINATION
ADAPTER
FLOOR REAR
CROSSMEMBER
QUARTER INNER
PILLAR
REAR PILLAR
GUTTER
MOUNTING BOLTS
6 x 1.0 mm
OUTER PANEL