Construction
NOTE:
This section explains the procedures after removal of all related parts. For the related parts' removal procedure, refer
●
to the appropriate Service Manual.
The component replacement procedure described here is only for new Honda-supplied parts, as needed, according to
●
the area and the degree of damage on the body.
If there is any damage to the center pillar, cut the [A] position, pry off the outer panel, and replace it.
●
NOTE: Select the cutting positions in consideration of the front side outer panel repair part (see page 1-14).
Replace center pillar outer separator A.
●
Check the center pillar stiffener position for damage. If necessary, replace it.
●
When replacing the center pillar stiffener, cut the [B] position at the roof side portion of the outer panel.
●
Replace the center pillar inner separator.
●
If necessary, replace the side sill reinforcement (see page 3-23).
●
OUTER PANEL
[VIEW: X]
[A]
ROOF SIDE
FRONT RAIL
CENTER
PILLAR
STIFFENER
OUTER
PANEL
FRONT PILLAR
OUTER
SEPARATOR
(Adhesive type)
OUTER PANEL
CENTER PILLAR OUTER
SEPARATOR B
(Adhesive type)
OUTER
58 mm
PANEL
(2.28 in)
[B]
35 mm
(1.38 in)
CENTER
PILLAR
STIFFENER
[B]
[A]
[X]
CENTER PILLAR
OUTER SEPARATOR A
[VIEW: Z]
ROOF SIDE
FRONT RAIL
[Z]
CENTER INNER
PILLAR
CENTER PILLAR
STIFFENER
SIDE SILL
REINFORCEMENT
CENTER PILLAR
INNER SEPARATOR
REAR DOOR RAIL SUPPORT
REAR DOOR RAIL
SUPPORT BULKHEAD
ROOF
SIDE RAIL
EXTENSION
200 mm
(7.87 in)
CENTER
PILLAR
STIFFENER
OUTER PANEL
3-29