Changing Access Codes - Scantronic 9800 User Manual

Changing Access Codes

The system will accept up to four different user access codes, the first of
which is pre-programmed. The user can allocate or amend all four codes at
any time, or amend the 'Duress' code as follows:
(a)
9800
POWER
FAULT
A
1
4
B
Prog
C
7
chime bell-test-walk
0
day OMIT
Enter access code.
(a)
9800
POWER
FAULT
A 1
4
B
Prog
C
7
chime bell-test-walk
0
day OMIT
Display will ask for old code (oc).
Enter old code.
(e) Press the 'Clear' button to register the new code in the system memory
and to return the system to the 'Day' state.
(f) Repeat steps (a) to (e) to allocate or amend the other three codes if
required. The user can also change the 'Duress' code in the same way,
by entering the old code, new code and pressing 'Clear'.
Note: If you are adding a 2nd, 3rd or 4th code for the first time, enter AAAA
for second code, BBBB for third code, CCCC for the fourth code and OMIT
OMIT OMIT OMIT for the Duress code when asked for the old code (oc).
This is the only time that these keys are used as an access code. When and
existing code is to be changed, the user must enter the old four-digit code.
(b)
- -
POWER
SERVICE OMIT
2 3
5 6
log
8 9
CLEAR
Press 'Prog' key (No. 4 key).
(b)
oc
POWER
SERVICE OMIT
2 3
5 6
log
8 9
CLEAR
Display will ask for new code
(nc). Enter new four digit code
9800
FAULT SERVICE OMIT
A
1 2 3
4 5 6
B
Prog log
C
7 8 9
chime bell-test-walk
0
day OMIT
CLEAR
nc
9800
FAULT SERVICE OMIT
A 1 2 3
4 5 6
B
Prog log
C
7 8 9
chime bell-test-walk
0
day OMIT
CLEAR
(see note).
17