Preparing The Units - Gaggenau AF 2 Series Use And Care Manual And Installation Instructions

Preparing the units

▯
The fitted unit must be level and have sufficient
load-bearing capacity.
▯
The max. weight of the extractor hood is 40 lbs
(18 kg).
Appliance dimensions and safety clearances
▯
Observe the appliance's dimensions.
▯
Comply with the safety clearances.
If the installation instructions for the gas cooking
appliances specify a different distance, the largest
distance must always be provided for.
Fitted units must be heat-resistant up to 194° F
(90 °C). The stability of the fitted unit must also be
guaranteed after the cut-out work.
To install the extractor hood in a top cupboard, the
extractor hood must be provided with the following
dimensions:
Width 24" (600 mm)
Depth min. 12 /
5
Depth min. 13 ¾" (350 mm) with lowering frame
Elevation min. 16 9 /
Elevation min. 24" (600 mm) with CleanAir air recir-
culation module
1 Make cut-out for the exhaust air pipe. To do this,
make an opening in the top or back panel of the
fitted unit with an additional recess for the
power cord.
" (320 mm)
8
" (420 mm)
16
2 Remove cabinet base, if installed. Mark the
fastening points on the inside of the cabinet and
use a bradawl to make indentations where the
holes are to be. To help you mark the fastening
points, use the mounting piece provided.
Body wall thickness: 5/8" (16 mm)
1 Screw the mounting pieces to the body on the
¨
left and right.
2 Remove the tabs from the bottom of the
©
mounting pieces.
19