Cutterblade Sharpening; Storage - Hayter Harrier 56 Owner's Handbook Manual

Cutterblade Sharpening

A slightly worn cutterblade may be re-sharpened. Both
blade edges must be sharpened equally to ensure balance.
Sharpen the cutterblade every 25 mowing hours or more
frequently if conditions require. Remove the cutterblade
from the mower and clean using a brush and water. In-
spect the cutterblade for signs of damage.
formance.
Ensure that the cutterblade is balanced. Use a screw driv-
er with a round shaft to support the cutterblade through
its centre hole. Hold the cutterblade horizontal and then
release. A balanced cutterblade will remain horizontal.
If the cutterblade is not balanced the heavy end will
rotate downwards. Sharpen the heavy end until the
cutterblade is correctly balanced.

Storage

Ensure that the cables do not become trapped at the pivot
points when collapsing the mower for storage. To store
ciently to allow it to be pivoted forwards to rest against the
mower. Take care to ensure that the control cables do not
become snagged at the pivot point and depress the engine
stop lever to prevent it being damaged through contact
30-45
with the engine.
Engines stored in excess of 30 days need to be protected
with Briggs & Stratton fuel additive or drained of fuel to
prevent gum from forming in the fuel system or on essen-
tial carburettor parts. To ensure your mower is maintained
in good working order it is important that the following
procedure is adopted. Refer to the Maintenance section
-
as necessary.
- Drain fuel from the engine by operating the engine until
it stops.
- Disconnect the spark plug lead.
- Change the engine oil.
- Remove the engine spark plug and pour 15ml of engine
oil into the engine cylinder and replace the spark plug.
Do not exceed the stated volume of oil as engine
damage may occur on re-starting. Do not replace the
spark plug lead. Slowly pull the engine start - grip once
to crank the engine. This will distribute the oil and help
prevent engine corrosion.
-
- Clean grass and debris from the engine cylinder,
bag is clean.
- Lubricate the mower and treat metal parts with a water
repellent anti-corrosion product.
- Cover the mower with a protective sheet and store it in
a dry, ventilated area.