Panasonic Toughbook CF-37 Series Reference Manual page 12

Touchscreen
Configuring the Touchscreen
Devices
Configure the device controller.
Hardware
Set the hardware resources.
Match this setting with the
setting for [Base I/O] in the
Setup Utility.
Settings
Set the general protocol
settings.
When needed, the touchscreen can be configured using the following steps.
1
Select from the taskbar or select [Settings] from [Start] -
[Programs] - [Updd]
The following screen will appear.
Windows
Set the "double-click"
settings.
Advanced
Set the advanced settings.
NOTE
The touchscreen can be used for only [Whole Desktop] setting in [Devices] -
[Modify] - [logical desktop segment]. This setting is default.
2
Make necessary changes
3
Click [OK]
NOTE
It is also possible to change the double-click speed in [Buttons] for [Start] -
[Settings] - [Control Panel] - [Mouse]. However, when [Double Click Speed] in
[Mouse] is changed, the double click time in [Windows] is also changed. In
addition, the setting becomes the setting for [Buttons] in [Mouse] after the
computer is restarted or enters the suspend or hibernation mode.
Immediately run [Calibrate] when the number of points of calibration is changed.
Calibration
Define the calibration setup.
Use when the cursor can not be pointed correctly with
your finger. (Needed if the alignment of the touchscreen
with the visual image change or adjust the display reso-
lution).
Status
Display the status of the controller.
About
Display the version number.
Button Modes
Set the button modes.
General
Set the general settings and func-
tions.
Events
Set the events that can be generated
by a controller.
NOTE
For more information, refer to [Help].
12
page 9