Honda 08E91-E22-100B Installation Instructions Manual page 16

55. Install the clip from the engine starter harness to the
fuse box bracket behind the fuse box.
FUSE BOX
BRACKET
56. Remove the ground bolt from the vehicle. Secure the
engine starter harness ground terminal with the
ground bolt you just removed.
Installing the Control Unit
57. Connect the antenna cable terminal and the engine
starter harness 18-pin connector to the control unit.
CONTROL UNIT
BRACKET
16 of 21
GROUND BOLT
Reuse.
FRONT
ENGINE STARTER
HARNESS GROUND
TERMINAL
ENGINE
STARTER
CLIP
HARNESS
ANTENNA CABLE
TERMINAL
Connect first.
FRONT
CONTROL
UNIT
ENGINE STARTER
HARNESS 18-PIN
CONNECTOR
58. Install the control unit on the control unit bracket.
59. Bundle the excess antenna cable with two wire ties
and secure it with one wire tie to the vehicle harness.
WIRE
TIES
60. Using isopropyl alcohol on a shop towel, clean the
872643AT
area where the engine starter label will attach.
HOOD
ENGINE
STARTER
LABEL
61. Remove the backing from the engine starter label.
Attach the engine starter label to the back of the
hood.
872644AT
AII 42460 (0908)
VEHICLE
HARNESS
Clean.
BACKING
© 2009 American Honda Motor Co., Inc. – All Rights Reserved.
ANTENNA
CABLE
872645AT
872646AT