Makita EVH2000 Original Instruction Manual page 13

3) Rotate the pressure dial and align the STARTING tab with the mark.
1) When the engine is cold, or when the fuel it refueled
(1) Set this machine on a flat space.
(2) Set the I-O switch to " I " position.
(3) Make sure that the throttle lever is the SLOW position.
(4) Continue to push the primer pump untill fuel enters into the primer
pump.
• In general, fuel enters into the carburetor by 7 to 10 Pushes.
• If the primer pump is pushed excessively, an excess of gasoline
returns to the fuel tank.
(5) Lifting the choke lever of the air cleaner right side, close the choke
lever.
(6) Hold the element cover with a left hand to prevent the engine from
moving, settle down to take the stable position.
(7) Pull out slowly the starter handle till a certain resistance is felt. Return
the starter handle backward once from this position, then pull it out
with force.
• Never pull the rope to the full.
• Once the start knob is pulled, never release your hand immediately.
Hold the start knob until it returns to its original point.
(8) When the engine starts, open the choke lever.
• Open the choke lever progressively while checking the engine
operation. Be sure to open the choke lever to the full in the end.
• In cold or when the engine is cooled down, never open the choke
lever suddenly. Otherwise, the engine may stop.
(9) Continue warm-up operation for 2 to 3 minutes.
(10) Rotation of the engine speed stabilizes and when from low speed
making at high speed rotation, if reaches the point where it
accelerates smoothly, it is completion of warming-up.
"STARTING" TAB
PRESSURE DIAL
SLOW
Throttle lever
Primer pump
13
switch
Close
Open