Diagnosis; Disassembly - Pioneer MJ-D707 Service Manual

QQ
3 7 63 1515 0

7.2 DIAGNOSIS

7.2.1 DISASSEMBLY

Removal of the Servo Mechanism Assy
1 Remove the screw A.
2 Disconnect the connectors (CN102, CN103, CN105), open the
hook of part A, and tilt the upper side of the CORE MAIN UNIT
ASSY to the front.
3 Disconnect the connector (CN101) at the rear of the CORE
MAIN UNIT ASSY and remove the CORE MAIN UNIT ASSY.
4 After the Carrier has been pushed in, move the Upper Slider to
the rear and stop it at the position where the Under Slider starts
to move.
4
Rear Side
Carrier
TE
L 13942296513
7 Remove the Servo Mechanism Assy.
Servo Mechanism Assy
www
.
http://www.xiaoyu163.com
Upper Slider
Move
Under Slider
5
Part B
x ao u163
y
i
7
http://www.xiaoyu163.com
2 9
8
2
CN105
Screw A
1
CN102
2
CORE MAIN UNIT ASSY
5 Shift part B to the position shown in the figure while raising the
Under Slider. (At the same time, the Upper Slider moves to the
front.)
6 Remove the Lock Plate. (One screw B)
Q Q
3 6 7 1 3 1 5
Screw B
Lock Plate
6
Caution for the time of installation of the servo
mechanism assy
Move the MD Pick-up to the innermost circumference.
After installation of the servo mechanism assembly, shift the
Upper Slider to the rear. (The Under Slider moves at the same
time, and the servo mechanism assy is fixed. When the Under
co
Slider is slide, this becomes the reason for switching ring
catching.)
.
MJ-D707, MJ-17D
9 4 2 8
CN103
2
3
CN101
0 5 8 2 9 9 4 2 8
Under Slider
Upper Slider
m
9 9
Part A
9 9
61