Details Of Error Display - Pioneer MJ-D707 Service Manual

QQ
3 7 63 1515 0
Removal of the Head Lifter
1 Remove the Lifter SP.
2 Tilt the Head Lifter to the rear and push part A to disengage it.
Head Lifter
2
Part A
TE
L 13942296513

7.2.2 DETAILS OF ERROR DISPLAY

Error Display
÷ DEFECT occurred 10 times continuously during REC-PLAY.
Can't REC
÷ Recordable cluster became 0 since DEFECT occurred during
÷ Address is unreadable. REC state can not be set for 20 seconds
÷ Determined as follows according to the channel status of the
Can't COPY
÷ The following occurred for digital signal input from D-IN during
D-IN UNLOCK
÷ No area for registering music number and character information
TOC FULL
÷ FTNO > LTNO.
UTOC R ERROR
www
÷ FTNO ≠ 0 or 1.
÷ UTOC recorded on DISC could not be read.
÷ Start address > End address.
UTOC ERR A
.
÷ Any one data of UTOC 0 to 4 has looped.
UTOC ERR L
http://www.xiaoyu163.com
1
Lifter SP
Push
Servo Base
Details of Error
REC-PLAY.
even after try again.
signals input from D-IN during REC-PAUSE or REC-PLAY.
1. Other than audio
2. Other than consumer use
3. Copy NG due to inversion of COPY bit of CD
REC-PAUSE, REC-PLAY, or CD FUNC playback
1. Digital IN PLL unlocked.
2. Locked at other than FS = 32, 44.1 and 48 kHz.
during REC-PLAY (music name, disc number, etc.)
x ao
y
i
http://www.xiaoyu163.com
8
Head Lifter Installation
1 Install part A in the Servo Base with the Head Lifter tilted to the
back.
2 Match the Head Lifter and the Servo Base as shown in the figure,
and then engage part B.
3 While holding part B with your hand, tilt the Head Lifter to the
front and install the Lifter SP.
Head Lifter
Head Lifter
2
Matching
Part B
Position
Q Q
3 6 7 1 3
÷ Check if there are scratches, dusts, fingerprints, or black
÷ Check if CD is copy-proof. (Example: CD-R, etc.)
÷ Check if D-IN signal line is normal.
÷ Replace with recording/playback disc with space for
÷ Replace with other discs to check if UTOC data is normal.
u163
÷ Replace with other discs to check if UTOC data is normal.
.
÷ Replace with other discs to check if UTOC data is normal.
MJ-D707, MJ-17D
2 9 9 4 2 8
Part A
3
Push
Part B
1 5 0 5 8 2 9 9 4
Measure
spots on disc. Check if disc fluctuates eccentrically or
moves up and down largely.
registering UTOC.
m
co
9 9
1
2 8 9 9
63