S E R I E S VOLUME INPUT SAMPLE POWER MENU ENTER MONO INVERT MUTE ® STEREO DAC PREAMPLIFIER DSPre HIGH DEFINITION MODEL DSPre STEREO DAC PREAMPLIFIER RS-232 PLYMOUTH, MINNESOTA +12V REMOTE INPUT MADE IN U.S.A. TRIGGER BAL1 BAL2 PROC...
MENU ENTER MONO SAMPLE INVERT Note: All DSPre functions are available on the DSPre hand held remote controller. All functions are indicated in the display window as they are selected. See ‘Description of Controls’ in this manual for more information.
Function also on remote control. The DSPre also has automatic muting to help Packaging protect system components during A.C. power interruptions or low line voltage. When sensing these Save all packaging accompanying this product.
(DVD Connections player, tuner, CD, etc.) to the PROC input or the Input Connectors: The DSPre provides five L/R sets amplifier(s) and speaker system could be damaged of analog input connectors: BAL1, BAL2, SE1, SE2, when the DSPre is unmuted.
When recording from performance as well as reliable service: the Processor input to the Record out of the DSPre, 1. Operate unit in upright and horizontal position, the level of the recording will be dependent on the preferably on solid, non-metal shelving.
WINDOWS SOFTWARE INSTALLATION INSTRUCTIONS: Installation of the DSPre HD Audio Device drivers is only necessary if you intend to use the USB 2.0 HS input on your DSPRE. Software installation is not necessary if you only intend to use the S/PDIF or AES/EBU inputs.
Page 10
Welcome panel. complete. Normally restarting your PC at this point is not required but If you do not see the “DSPre OUT 1/2" listed in the SOUND panel after installation you should do a restart of your PC; see page 14 for details.
Page 11
Remember, to see the DAC8 window by clicking the X in the upper right corner name in the SOUND panel you must have the DSPre of the window. The only time you need to go back ON and connected to the USB port.
Page 12
1/2 listed in the sound panel after installation, first sample rate being sent to the DSPre you should make sure your DSPre is connected to your PC via a simply use the DAC8 control panel to set the DSPre high quality USB cable and plugged into an sample rate to that of the music you are playing.
Page 13
44.1 CD to 176.4kHz and send it to the managers available enhance your music DSPre; the 176.4 LED will be lit. To play a 44.1 CD at experience; on PC’s, J Rivers Media Center®, 44.1kHz, simply set the sample rate in the Audio MIDI Mediamonkey® FooBar® three that Setup Utility to 44100.0kHz.
USB Controller, then USB Root Hub panel and click inside the unit. Refer any needed on Properties and then Advanced; there it will say service to your authorized Audio Research dealer or the speed of that USB port. other qualified technician.
Research Customer Service Department. Outside the United States, the authorized importing retailer or distributor has accepted the responsibility for warranty of Audio Research products sold by them. The specific terms and remedies for fulfillment of the Limited Warranty may vary from country to country.
Need help?
Do you have a question about the DSPre and is the answer not in the manual?
Questions and answers