Rinnai REU-16FUA-E Infinity 16 i Installation And User Manual page 35

TEMPERATURE CONTROLS - INSTALLATION
MC-45-SR-EU / BC-45-SR-EU / BSC-45-SR-EU
1. Determine the most suitable position for the
temperature controller.
2. Drill 3 holes in the wall as shown in fig. 1, one
for the cable and two for the securing screws.
Ensure holes are drilled deep enough. Fit wall
plugs if needed. (ensure controller is level.)
3. Remove the face plate from the controller
using a flat screwdriver. Take care not to
damage the cover (fig. 2.)
4. Run the cable provided through the hole in the
wall and connect to the controller. (fig. 3.)
5. Connect the cable to the temperature
controller. If the cable cannot run in the wall
cavity the plastic side or bottom knockout
should be removed.
6. Fix the controller to the wall and fasten with
the phillips head screws supplied as shown in
(fig. 4.)
7. Replace the face plate.
Connecting Additional Controllers
Additional controllers are installed in the same
manner.
Cables should be run in parallel, either from one
controller to the next, or all controllers back to the
Infinity.
Temperature Controller