Advanced Settings - SatKing PRO MAX User Manual

Modify Transponder (TP) Mode
i. Press MODE twice to enter Modify TP MODE and press OK.
NOTE
To select and set numbers, use arrow buttons to see available options. The numbers, adjust individually with the
cursor and press OK to move to next option. You only need to use this function if the satellite operator changes
all it's parameters.
ii. Select the satellite you want to modify, as example "00 VAST ~ 05 OPTUS D3" and press OK.
iii. Select TP number among "00~02" and press OK. (Three TP's are programmed for each satellite)
iv. Repeat the same process by inputing data for FREQ (frequency) and SYMBOL (symbol rate).
v. Select type of signal DVBS or DVBS2 and press OK.
vi. Select polarlisation VER (vertical) or HOR (horizontal) and press OK.
vii. Select YES or NO to save and/or go back to first stage of TP Modify.
viii. To exit, press MODE and PRO MAX will return to previous status.
ix. For manual TP data RESET, press SET twice and then select YES and press OK.
Restart PRO MAX to apply the reset to your next start up.
Change VAST STB Home Transponder (TP)
In very low signal areas it may be an advantage to change the home TP in your VAST receiver, this
will allow the VAST receiver to search for the strongest TP first
NOTE
Due to signal levels all channels may scan in but not be available.
SatKing VAST Receivers
i. Press Menu_Select Installation and press "OK"_Enter Password 1234.
ii. Press yellow button (TP Edit)_Change frequency to 11807.
iii. Green bars should appear down the bottom of the TV screen, once this happens press the red
button (start search).
UEC DSD 4121
i. Press Menu_Select #6 Advanced Options and press "OK".
ii. Select #2 Install Setup_press "OK".
iii. Enter password 1234_Select #1 Sat Signal Setup_press "OK".
iv. Select #1 Freq MHz_press "OK".
v. Manually enter 11807 and press "OK". Select #5 Accept these settings and press "OK".
vi. Select #4 satellite Rescan and press "OK".

5. Advanced Settings

SatKing PRO MAX User manual - 12