Table of Contents
Advertisement
angle frame L allows for alignment to adjoining cupboards. Finally replace door front and
grille.
Fitting the hood between cupboards on either side
(See Fig.6)
There are 2 holes on either side of the cooker hood. To gain access first remove grille (see
Fig.2) by taking hold of knob Y and carefully lifting the grille up and out of groove behind
which it is retained. The grille is then completely free to remove by carefully pulling down
and out of the hood. Remove sloping door front E (Fig.4) by pulling inwards the plastic
stops connected to the special spring locking knobs H (Fig.4) until the door is eased
forward out of its side retaining channels.
This will allow for correct position of cooker hood against cupboards on either side. Mark
positions for the screws, remove cooker hood, drill 2 holes on each side where marked.
Should the cupboards not be considered strong enough, angle frame L (Fig.2) can be
removed from hood and used as additional support on the rear wall. Re-check positioning
of hood, screw angle frame L to wall, replace hood and screw into cupboards, as
previously.
Fixing the front panel
Remove grille and sloping door front. Drill holes through sloping door front as indicated
(see Fig.5), then screw cabinet door to front of hood door with screws (not provided).
Replace completed door by first inserting it into upper slides and then pulling the plastic
stops on the spring locking knob H to allow entry into lower slide retaining channels and
push until locking occurs. Carefully replace the grille.
• External Exhausting
(See Fig.1)
Connect the external exhausting venting pipe, which must have an inner diameter of 100
mm, to the coupling flange B.
Note: Venting kit not supplied.
According to the positioning, the pipe is then directed to the most convenient outside wall,
or through the ceiling, having no more than two 90° bends in the entire run.
Important: When fitting venting kits, please follow assembly instructions provided by
venting kit manufacturers.
Safety Warning: Under no circumstances should the hood be vented through that of other
appliances.
• Internal Exhausting
(See Fig.2)
Charcoal filters are used to purify the air which will be recycled into the room. The filters
cannot be washed or regenerated and must be replaced every 4 months.
The charcoal filters are supplied as an optional extra, please phone Belling Spares
department on 01709 579907 and quote part number CHT28.
Saturation of the activated charcoal depends on more or less extensive use of the hood,
the type of kitchen and the regularity of cleaning the grease filter.
Proceed as follows:
1. To gain access first remove grille (see Fig.2) by taking hold of knob Y and carefully lifting
the grille up and out of groove behind which it is retained. The grille is then completely free
6
Advertisement
Table of Contents
