Starting Operation - Bosch EXACT 2 Original Instructions Manual

Hide thumbs Also See for EXACT 2:

Original instructions manual (444 pages)

Manual (280 pages)

Original instructions manual (327 pages)

Table Of Contents

Table of Contents

OBJ_BUCH-529-001.book Page 27 Wednesday, December 5, 2007 12:18 PM

Inserting/Removing the Voltage Adapter

(see figure E)

Type 0 602 490 431/... 433/... 435/... 437/

... 439/... 441/... 443/... 445/

... 447/... 469

Select the voltage adapter that matches the rat-

ed voltage of your power tool.

The voltage adapters may be differentiated, de-

pending on the voltage, by the color of the hous-

ing of the D-sub connector 16. The housing of

the D-sub connector for a voltage of 9.6 V is light

blue in color, and that for a voltage of 12 V is red

in color.

The adapter housing 18 may be mounted in

or dismounted from the industrial battery-

operated screwdriver only when the con-

stant voltage regulator is switched off or

when the connector 16 is disconnected

from the constant voltage regulator.

Move the rotational direction switch 3 to the

center position. This action locks the on/off trig-

ger switch 6 in the "off" position, which pre-

vents the tool from running. Insert the adapter

housing 18 into the handle of the power tool. In-

sure that the adapter housing is in the correct

position and that the locking buttons 4 engage

securely into the handle of the power tool.

Subsequently, plug the connector 16 of the volt-

age adapter 15 that matches your power tool in-

to the connection socket. Screw the connector

16 tightly in the connection socket 15 by tight-

ening the two screws 17 by hand.

To remove the voltage adapter, loosen the two

screws 17 on the connector 16 of the switched

off constant voltage regulator and and pull the

connector out of the connection socket 15. Sub-

sequently, squeeze the locking buttons 4 on

both sides and pull the adapter housing 18 out

of the hande of the power tool.

Type 0 602 492 431/... 433/... 435/... 439/

... 441/... 443/... 445

These industrial cordless screwdrivers cannot

be operated with constant voltage regulator.

Bosch Power Tools

Changing Application Tools on the Head

with Quick-change Chuck (see figure F)

When working with an application tool, pay

attention that the application tool is firmly

seated on the tool holder. When the applica-

tion tool is not firmly connected with the tool

holder, it can come loose again and not be

controlled.

Inserting

Pull the quick-change chuck 19 to the front. In-

sert the tool 9 into the tool holder 8 and release

the quick-change chuck.

Use only insertion tools with fitting end pieces

(1/4" hexagonal).

Do not attempt to insert quick-change type drill

bits into this chuck. Centre grip screwdriver

equipped with shut-of clutches are not designed

for drilling applications. The chlutch can shut-off

automatically and without warning. Attempting

to restart drilling after shut-off has been

reached can cause the power tool to twist out of

your hand until the clutch again reaches shut-

off.

Removing

Pull the quick-change chuck 19 to the front.

Take the tool 9 out of the tool holder 8 and re-

lease the quick-change chuck.

Operation

Use safety equipment. Always wear

eye protection. Safety equipment

such as dusk mask, non-skid safety

shoes, hard hat, or hearing protec-

tion used for appropriate conditions

will reduce personal injuries.