Assembly - Husqvarna 87521RES Owner's Manual

TO ASSEMBLE GRASS CATCHER
(See Fig. 3)
1. Put grass catcher frame into grass bag with rigid part
of bag on the bottom. Make sure the frame handle is
outside of the bag top.
2. Slip vinyl bindings over frame.
NOTE: If vinyl bindings are too stiff, hold them in warm
water for a few minutes. If bag gets wet, let it dry before
using.
VINYL
BINDINGS

ASSEMBLY

FRAME
HANDLE
FRAME
OPENING
FIG. 3
TO PREPARE BATTERY (See Fig. 4)
NOTE: Your battery must be charged before you can start
your lawn mower.
1. Con nect battery charger con nec tor (male) to harness
con nec tor (fe male).
2. Plug battery charger into 110 volt A.C. outlet.
3. Leave battery charger connected for 24 hours before
starting your engine for the first time.
4. After charging, disconnect harness connector (female)
from bat tery charger connector (male).
Connect your battery charger to charge battery as re-
quired.
IMPORTANT: THE ENGINE WILL NOT RECHARGE YOUR
BATTERY. AT THE END OF THE MOWING SEASON THE BATTERY
SHOULD BE CHARGED FOR 48 HOURS TO PROTECT THE
BATTERY DURING WINTER STORAGE.
CAUTION: Always disconnect the
en gine connector (male) from the
battery connector (female) to prevent
ac ci den tal start ing when transporting
or stor ing your lawn mower after the
season.
BATTERY CHARGER
HARNESS
CONNECTOR
(FEMALE)
CHARGER
CONNECTOR
(MALE)
ENGINE CONNECTOR (MALE)
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to be used as a
mulcher. To convert mower to bagging or discharging,
see "TO CON VERT MOWER" in the Operation section of
this man u al.
5
BATTERY
FIG. 4
BOX