5-In-1 Sensor Installation - ACU-RITE 02032CAUDI Instruction Manual

5-in-1 Sensor Installation Guidelines
INSTALLATION HEIGHT
feet) off the ground, in an open area. Higher is better for wind measurements-
the National Weather Service recommends 10 meters (33 feet) high!
MOUNTING OPTIONS
onto wooden posts or surfaces that are 2"x4" or larger. The sensor can also
be mounted directly to 3/4" steel pipe (available at hardware stores and home
centers).
LEVEL INSTALLATION
the top of the sensor to ensure level installation
for accurate wind and rain measurement.
SOLAR CELL INSTALLATION
with the solar cell facing NORTH. This ensures
the cell receives as much sun as possible and
orients wind direction.

5-in-1 Sensor Installation

1. Fasten mounting base (included) to a post or
pole (not included) using the 4 longer screws
included in the hardware bag.
2. Insert the mounting base into the hole on the
bottom of the sensor.
3. Make sure the arrows on the top of the
sensor are pointed in the proper direction
and the bubble level is centered. The solar
cell should be facing north to properly orient
the wind direction.
4. Fasten the sensor into the mounting base using the 2 shorter screws included
in the hardware bag.
Clear Data Collected During Installation
When installation is complete, clear erroneous data from the display unit by
pressing the "CLEAR RECORD/ RESET" button, on the back of the display
inside the battery compartment. This button will clear data recorded since
12:00 am.
Basic Setup is Complete
The 5-in-1 sensor will now synchronize with the display unit. It may take a few
minutes for synchronization to complete. If both or one of the units appear to
be functioning improperly, please refer to the troubleshooting section.
Mount the sensor at a minimum height of 1.5 meters (5
The included mounting bracket is design to screw directly
Use the bubble level on
Install the sensor
The 5-in-1 sensor is now ready to use.
NO OBSTRUCTIONS
ABOVE OR AROUND
N O
14
R T H
1.5 meters
(5 feet)