Table of Contents
Advertisement
39. Pick up your iPod and turn it on. The ipod display will illuminate.
Note: Before starting the test check the iPod being used has several playlists
recorded and the 1Khz test tones are loaded and that has several photos
stored. (Test tones are supplied by Russound)
40. Plug the iPod into the iBridge Dock.
41. The Ipod will display the Rossound Logo for several seconds and go dark.
(The ipod illumination time is dependent upon your iPod backlight setting)
42. The UNO-S2 Keypad will display the name of the ipod momentarily.
(This is the name you gave your iPod when loading iTunes on your computer)
43. Music will automatically be heard out both speakers of the CAV6.6.
(A song from any stored on the iPod will be played at this time)
44. The UNO-S2 will display and scroll the song being played.
45. Press the Volume UP or Down buttons paying close attention that the music is clear
not distorted. Confirm that music is heard from both speakers.
Observe the two waveforms on the Oscilloscope and ensure there is no distortion.
iBridge & RNET AV Decoder
Revised August 7, 2006
14 of 33
Advertisement
Table of Contents
