Honeywell HFD-010 Series User Manual page 6

REMOVING / CLEANING THE IFD
• Note that the filter may still be discolored even after washing.
This is acceptable and will not affect performance.
• Allow the ifD Micro-filter to dry for a few hours or overnight.
®
Micro-filter is completely dry, place back into the air purifier.
• When the ifD
®
Make sure you insert the filter according to the directional arrows on the filter.
CAUTION:
• Never place a wet ifD
• Do not use any solvents, strong cleaning agents or flammable liquids to clean the ifD
CLEANING THE WASHABLE PRE-FILTER (ALL MODELS)
To remove the pre-filter:
Press the top tab to release the pre-filter from the filter
assembly (Fig. 14).
To clean the pre-filter:
The particle pre-filter helps pick-up large airborne particles
that enter the filter. The pre-filter can be removed and rinsed
by hand under warm water (Fig. 15). Let the pre-filter dry
completely before inserting it back into the unit.
Some models are shipped with bonus odor control pre-filters that are not washable. After the pre-filters
have lost their odor reducing capability over time (approximately 3 months), you can order replacement
Odor-Lock pre-filters by calling the Kaz USA, Inc. Consumer Relations Department at 1-800-477-0457.
™
INSTALLING THE ODOR-LOCK
• To replace the permanent, washable pre-filters with the
Odor-Lock pre-filters, remove the standard washable
™
pre-filter assembly by pushing on the top tab (Fig.16).
• The pre-filter assembly has two pre-filters that will need
to be popped out of the pre-filter frame. Hold the frame
steady from the side while pushing in the center of each
pre-filter from the back side of the frame (Fig.17). This
will separate the pre-filter from the frame and you can
then pull it completely away from the frame (it will snap
out) (Fig.18). Save the permanent washable pre-filters
as you may choose to use them in the future.*
• To insert the Odor-Lock
frame, line the tabs on the pre-filter up with the frame
notches and snap into place (Fig.19).
• Install the Odor-Lock
lower tab of the pre-filter frame into the filter assembly
until you hear a "click" (Fig. 20).
• Align the complete filter assembly with the opening in
the unit and insert back into the unit (Fig. 21).
NOTE: The Odor-Lock
6
MICRO-FILTER FOR ALL MODELS FILTER (CONTINUED)
®
Micro-filter in your air purifier.
®
PRE-FILTER(S) (HFD-014, HD010WHS, HD010LHS, HD010RHS ONLY)
™
pre-filters into the pre-filter
™
filter assembly by inserting the
™
filters are not washable.
™
Fig. 14
Fig. 16
Fig. 18
Fig. 20
Micro-filter.
®
Fig. 15
Fig. 17
Fig. 19
Fig. 21