NEC RSC1711 Owner's Manual page 13

⁄EAuto Operation Mode
( LED lamp ON)
1 Press the Start/Stop Button.
2 Select Auto Operation.
Press the Operation Mode Selection Button.
Each time the button is pressed, operation mode is shifed in the arrow direction.
Set the temperature.
3
4 During Auto Operation.
• It is impossible to alter the indoor fan speed during Auto Operation because it is already set
to the best position by Fuzzy rule.
• If the room air conditioner is not operating as desired, switch to cooling mode or other
mode.
• During Auto Operation, pressing the Air-flow direction control button makes vertical louver
swings up and down automatically according to 1/f rhythm. If you want to stop the 1/f swing
of the vertical louver, press again the Airflow Direction Control Button.
Operation Display
Soft Dry Operation
Cooling Operation
• Operation mode, set temperature and fan speed are automatically
set by Fuzzy rule on the basis of sensing the room temperature.
• If you want to change the set temperature, press room
temperature setting button.
• The cooler or warmer you feel, the more times (up to two times)
you press the button.
• Then the set temperature will be changed automatically by micom
control.
To raise the Temperature. (When you feel too cool or cold)
To lower the Temperature. (When you feel too warm or hot)
— 13 —
• Two short beeps will sound and the
operation lamp will light up.
Heating Operation
Auto Operation
(Heat pump model only)