Midi Operation; Setting Midi In; Setting Midi Out - Chauvet Stage Designer 50 User Manual

Midi Operation

The controller will only respond to MIDI commands on the MIDI channel that it is assigned to. All MIDI control is
performed using Note on commands. All other MIDI instructions are ignored. To stop a chase, send the
blackout on note.

Setting MIDI IN

Action ·
1. While holding down the RECORD button,
simultaneously tap Flash button #1 three
times. The display reads MIDI CHANNEL
IN to indicate channel setup is available.
2. Select the MIDI control channel (1–16) by
tapping Flash buttons 1–16. The relevant
channel LED lights indicating MIDI IN
channel is set.
3. While holding down RECORD, tap the
REC EXIT button to exit MIDI setting.
MIDI
NOTE
70-117

Setting MIDI OUT

Action ·
1. While holding down the RECORD button,
simultaneously tap Flash button #2 three
times. The display reads MIDI CHANNEL
OUT to indicate channel setup is available.
2. Select the MIDI control channel (1–16) by
tapping Flash buttons 1–16. The relevant
channel LED lights indicating MIDI OUT
channel is set.
3. While holding down RECORD, tap the
REC EXIT button to exit MIDI setting.
Stage Designer™ 50
F (TURN ON/OFF)
UNCTION
22-69 Trigger scenes 1-48 (100%)
Activate Channel 1-48
118
FULL-ON
119 DARK (momentary blackout)
120 HOLD
121
Turn on or off AUDIO
MODE: CHASE◄ ►SCENE
122
123 MODE: 1-12A_1-12B
124 MODE: 1-24A
125 Step
126 BLACKOUT
127 Channel page (1–24, 25–48)
¥
Notes
This is the Channel that the controller will receive MIDI
note commands.
¥
Notes
This is the Channel that the controller will transmit MIDI
note commands.
19 Rev. 9