CONTENTS Precautions & Maintenance Quick Start Guide Dashboard Installation Removal / Re-Attachment of the Face Connecting the System Basic Operations Audio Functions System Menu Radio Operation iPod / iPhone Operation WWW.FUSIONENTERTAINMENT.COM Media Playback (USB/SD) Bluetooth Operation (700BT Only) Additional Media Playback Options Troubleshooting How To Reset The Unit Product Specifications...
PRECAUTIONS & QUICK START GUIDE MAINTENANCE TUNER REGION SETTING GENERAL When the unit is powered up for the first time (or the battery is disconnected or runs flat), you will need to set • When cleaning the vehicle, do not get water or cleaning your tuner region.
DASHBOARD INSTALLATION REMOVAL / ATTACHING THE FACE The following illustration shows a typical installation. If you have any questions or require information regarding 1. Press the Panel OPEN button. installation kits, consult your car audio retailer. 2. Hold the left-hand side of the Face and pull forward If you are not sure how to install this unit correctly, have it 3.
Page 6
CONNECTING THE SYSTEM WIRING DIAGRAM CA-ML700BT...
Page 7
700/BT BASIC OPERATIONS b) ENTER. In Media playback mode and Menu functions, press this button to confirm a selection (ENTER). 5. AUDIO Press this button to enter the Audio Menu mode. 6. DISP - DISPLAY a) In MP3/WMA playback mode, press to display ID3 information: Track number and elapsed play Time - >...
Page 8
Press & hold for 2 seconds to transfer the call from the b) FILE & TRACK UP/DOWN. In USB/SD media playback CA-ML700BT back to the Mobile Phone. mode, press these buttons to skip a chapter, track or file. 16. ESC/END (700BT Only) c) FAST FORWARD/BACK.
AUDIO FUNCTIONS NOTE If the Subwoofer RCA output is set to “OFF”, then the SW LPF & Audio functions are easily accessable on the ML700/700BT. SWAM functions will not be displayed. AUDIO MENU. Press the AUDIO BUTTON (button 5) EQUALISER OPERATION to access the Audio Menu mode.
1. Select you preferred Band. Generally you would use FM1 or with selectable key illumination in the following colours: AM1 to save you favourite stations (6 stations per band). If you FUSION Green and Ocean Blue. need to store more stations, you can use FM2/3 or AM2 for AM stations.
TUNE TO A SAVED or PRE-SET STATION then follow the steps below: 1. Select the relevant BAND PLAYLIST Rotate the Encoder Volume control to select 2. Press the Preset Station Number corresponding to your your desired Playlist and press ENTER to start play. required Pre-Set station.
RANDOM PLAY NOTE the volume level can be adjusted while the unit is paused Press RDM to cycle between the following modes: RDM FLD – Plays the current album randomly. • Press the to skip forward to the beginning of the next or previous chapter/track.
Page 13
Connect the external device to AUX in Note on some phones, you may need to select “SET AS jack using a 3.5mm stereo Aux In cable AUTHORISED” or similar to ensure the CA-ML700BT will (not supplied) located on the face, then automatically pair on subsequent usage.
Page 14
TO REDIAL A NUMBER PAIRED NOTIFICATION DISPLAY When the Bluetooth device is paired with the CA-ML700BT, the 1. During normal head unit operation, press the ANSWER Bluetooth Icon will appear on the LCD display. This should button to call the last number dialled by the paired occur whenever you use the system and the paired device is in mobile phone.
Page 15
ENTER to make your selection. 1. If the Bluetooth device is paired and you want to disconnect it from the CA-ML700BT, press MENU to • Rotate the Encoder Volume control to select the desired enter the System Menu.
Page 16
• To perform Intro Play on files in the current folder only, the storage media [RDM ALL] is displayed. press & hold the INT button while in Intro Mode. [INT) will • To cancel Random Play, press RDM to display the current be displayed on the LCD along with the folder number.
TROUBLESHOOTING Display shows ERR-5 • Communication error. The USB/SD device could be Before going through the check list, please check the damaged or corrupted. Please re-format (Fat32 only) or try wiring connection diagram. If problems persist, please a different device. consult your Car Audio dealer.
PRODUCT SPECIFICATIONS SUPPORTED FILE FORMATS Power Supply 12V DC (11-16V), Negative Ground Fuse MPEG1/2/2.5 Layer 2/3 Speaker Impedance 4 – 8Ω WMA Version 7/8/9 Power output MOSFET 50W MAX x 4 channels Sampling frequency RMS output 22W x 4 @ 10% THD MPEG1 32/44.1/48 kHz Pre-AMP output...
Page 19
LICENSING REGISTER YOUR PRODUCT ONLINE: For your own peace of mind, register your product purchase online at www.fusionentertainment.com We’ll keep you up to date with any news related to your product or new accessories to help you get the most from “Made for iPod and “Made for iPhone”...
Page 20
• The product was used with or connected to an accessory not supplied by FUSION or fit for use with FUSION product, or used in a manner other than its intended use. If a problem develops during the limited warranty period, the consumer should take the following step-by-step procedure: The consumer shall return the product to the place of purchase for repair or replacement processing.
Page 21
Acts of god (force majeure), exposure of product to food spills, or any other type of fluid ingress • Using the product in a way for which was not intended to be used or connecting it to an accessory not supplied by, specified by, or authorised by Fusion •...
Page 22
Le numéro de série du produit ou le code de date de l’accessoire a été effacé, dégradé ou altéré. • Le produit était utilisé avec ou connecté à un accessoire non fourni par FUSION ou incompatible avec le produit FUSION, ou a été utilisé pour un usage autre que celui pour lequel il est prévu.
Page 23
FUSION, incluida la falta de piezas consumibles tales como fusibles, y la rotura o daños ocasionados a las antenas, salvo que hayan sido causados directamente por materiales o fabricación defectuosos, y el desgaste natural...
Page 24
Il numero di serie del prodotto o il codice di data di un accessorio sia stato rimosso, reso illeggibile o alterato. • Il prodotto sia stato usato insieme a o in collegamento con un accessorio non fornito da FUSION o inadatto all’uso con il prodotto FUSION, o sia stato utilizzato per scopi diversi da quello a cui è destinato.
Page 25
Die Seriennummer des Produkts oder der Zubehörcode wurde entfernt, ausgestrichen oder abgeändert. • Das Produkt wurde mit einem Zubehörteil verwendet oder an ein Zubehörteil angeschlossen, das nicht von FUSION geliefert bzw. für die Verwendung mit dem Produkt von FUSION nicht geeignet war oder unsachgemäß verwendet wurde.
Page 26
ВСЛЕДСТВИЕ ИСПОЛЬЗОВАНИЯ ИЛИ НЕВОЗМОЖНОСТИ ИСПОЛЬЗОВАНИЯ ПРОДУКТА. • Компания FUSION не берет на себя и не уполномачивает никакие центры обслуживания, лица или субъекты брать на себя от ее имени никакие другие обязательства или ответственность помимо тех, которые явно предусмотрены этой гарантией.
Page 27
Het serienummer van het product of de datumcode op het accessoire is verwijderd, onleesbaar gemaakt of veranderd. • Het product is gebruikt met of aangesloten op een accessoire dat niet door FUSION is meegeleverd of niet geschikt is voor gebruik met het FUSION-product, of gebruikt op een wijze anders dan het bedoelde gebruik.
Need help?
Do you have a question about the CA-ML700BT and is the answer not in the manual?
Questions and answers