Honda umc435 Owner's Manual page 7

For both shoulders
(UMC435)
CARRYING
HARNESS
CARRYING
HIP PAD
HARNESS
LATCH
2. Adjust the length of the harness as shown in the figures below.
To make it shorter
1
2
3. Roll the end of the harness toward your body and fasten it.
(UMC435)
Roll the end of the
harness and fasten it.
(There is one applicable
point on the back side of
your body)
Check the Quick-Release Latch
1. Put on the carrying harness.
2. Check that the latch is released as soon as the quick-release
latch tab is pulled upwards while holding the hip pad with your
left hand.
For single shoulders
(UMC425)
CARRYING
HARNESS
HIP PAD
To make it longer
2
1
(UMC425)
Roll the end of the
harness and fasten it.
3. Insert the latch tongue in the slot of the quick-release latch to
reattach the powerhead to the carrying harness.
HIP PAD
If the latch is not released, have your device inspected and repaired
by your servicing dealer.
Attachment Installation/Removal
Check the joint area:
1. Check to see if the set pin knob moves smoothly.
2. Check to see if the joint knob tightens and loosens smoothly,
and if there is any damage.
3. Make sure there is no debris in the groove and inside the joint
holder.
Installation:
Running this engine without an attachment in place
could cause an unsafe condition.
Moving parts could cause severe injury.
Do not run the engine without an attachment properly
secured.
1. Turn the set pin knob to the lock position and loosen the joint
knob.
2. Align the " " mark on the attachment with the joint projection
which also aligns the key of the attachment with the joint
groove.
JOINT HOLDER SET PIN KNOB
PROJECTION
2
LOOSEN
JOINT KNOB
QUICK-RELEASE
LATCH TAB
QUICK-RELEASE
LATCH
LATCH TONGUE
SLOT
HOOK
(Back side of the portion where
the attachment is connected)
KEY
1
LOCK
3
ATTACHMENT
JOINT HOLDER
GROOVE
7