Cooling Fins; Fuel Filter And Fuel Tank; Fuel Tube - Honda umc435 Owner's Manual

COOLING FINS

Inspection
1. Loosen the 5 mm socket bolt, then remove the top cover.
2. Inspect the engine cooling fins, and clean out debris if
necessary.
COOLING FINS
(Inside the top cover)
3. Install the top cover, and tighten the 5 mm socket bolt securely.

FUEL FILTER AND FUEL TANK

Fuel filter inspection and Fuel tank cleaning
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when refueling.
• Stop the engine and let cool before refueling.
• Keep heat, sparks, and flame away.
• Refuel only outdoors.
• Wipe up spills immediately.
1. Check that the engine oil filler cap is tightened securely.
2. Remove the fuel tank cap, and drain the fuel into an approved
gasoline container by tipping the powerhead toward the fuel
filler neck.
3. Pull out the fuel filter with the mechanic's wire from the fuel
4. Inspect the fuel filter. If the fuel filter is dirty, wash it gently
5 mm SOCKET BOLT
TOP COVER
5. Remove water and dirt from the fuel tank by rinsing the inside
6. Insert the fuel filter into the fuel tank and tighten the fuel tank

FUEL TUBE

Inspection
Check fuel tubes for cracks and any other deterioration and confirm
that there is no leakage of fuel on the fuel tubes. If you notice any
abnormal symptoms on the fuel tubes, contact your Honda
servicing dealer.
FUEL TUBES
filler neck gently.
with non-flammable or high flash point solvent. If the fuel filter
is excessively dirty, replace it.
FUEL FILTER
of the fuel tank with non-flammable or high flash point solvent.
cap securely.
ENGINE OIL FILLER CAP
FUEL FILLER NECK
FUEL TANK CAP
17