Troubleshooting Guide - New Balance 1600 Owner's Manual

PROBLEM
Treadmill will not start
_____________________________________________________________________________________________________________
Treadmill Speed Surges
_____________________________________________________________________________________________________________
Treadmill Belt will not move -
ERR 1 on screen
_____________________________________________________________________________________________________________
Incline will not operate -
ERR 3 on screen
_____________________________________________________________________________________________________________
Treadmill Belt Slipping
_____________________________________________________________________________________________________________
Treadmill Noisy
_____________________________________________________________________________________________________________
Inaccurate pulse rate
_____________________________________________________________________________________________________________
Inaccurate heart rate strap

TROUBLESHOOTING GUIDE

CAUSE
1. Not plugged in
2. Not turned on
3. Safety Key not on correctly
4. Circuit Breaker opened in home
5. Treadmill Circuit Breaker tripped
1. Motor Controller not set properly
1. Lost speed input signal
1. Lost incline signal
1. Walking Belt loose
2. Deck needs lubrication
1. Loose hardware
2. Motor straining
3. Clicking sound - Roller knocking
1. Too much hand movement
2. Palms too wet
3. Gripping hand grips too tight
4. Wearing rings
1. Chest strap pick-ups not moist
2. Electrical interference
CAUTION
The Treadmill will shut off when the electricity load
is above it's capacity (example: power surge or storm).
To restart the Treadmill, please follow the procedure
below:
A. Unplug the power cord from the Treadmill's socket.
safety switch
B. Push in the safety switch.
C. Plug the power cord back into the Treadmill's socket.
NOTE: DON'T PUSH IN THE SAFETY SWITCH BEFORE
on/off switch
power cord
1. Plug into three prong grounded outlet
2. Turn the on/off button on
3. Put Safety Key on Console where
indicated
4. Reset home breaker
5. Reset Treadmill Circuit Breaker
(see below)
1. Call 800-497-5831 for service
1. Call 800-497-5831 for service
1. Remove and replace Safety Key and
Treadmill will recalibrate
1. Tighten Walking Belt (see page 13)
2. Lubricate Belt and Deck (see page 14)
1. Tighten all visible Screws, Nuts, and Bolts
2. Check Belt tension - 3 finger test
(see page 13)
3. Adjust Rear Rollers - check for tension
(see page 13)
1. Stand on Side Rails to get accurate
pulse reading
2. Dry palms
3. Grip using moderate pressure
4. Remove all rings
1. Moisten pick-ups on chest strap
2. Keep at least six feet away from
Televisions, Computers and
Fluorescent Lights
UNPLUGGING THE TREADMILL'S POWER CORD.
CORRECTION
29