Automatic Switch Off / Interior Light; Switching Off The Appliance; Interrupting The Programme - Siemens SN... Operating Instructions Manual

Automatic switch off after end
of programme or interior light*
* depending on model
To save energy, the dishwasher can be
automatically switched off 1 min or 120
min after the programme ends.
The setting can be selected from :
to : .
: Appliance does not
switch off automatically.
The interior light 1"
comes on when the door
is opened irrespective of whether
the ON/OFF switch (
is switched on or off. When
the door is closed the light is off. If
the door is open for longer than 60
min., the light switches off
automatically. The interior light 1"
is lit only when the set value :
is selected.
: Appliance switches off after 1 min.
: Appliance switches off after 120 Appliance switches off after 120 Appliance switches off after 120
min.
1. Close the door.
2. Switch on ON/OFF switch (.
Switch on ON/OFF switch Switch on ON/OFF switch
3. Hold down programme button #
Hold down programme button Hold down programme button
and press START button h
and press START button and press START button
until : ... is indicated on the digital ... is indicated on the digital ... is indicated on the digital
display.
4. Release both buttons. Release both buttons. Release both buttons.
The LED for button # flashes
and the digital display )* displays
the factory setting :
5. Keep pressing programme
button # until the value
indicated on the numerical display
)*.
Au t o m a t i c s w i t c h o f f / in t e r i o r l i g h t
( (
. .
h h
.
: ... is
Operating the appliance
To change the setting:
1. Press programme button 3.
Each time the button is pressed,
the set value increases by one level;
when the value of :
reached, the display jumps back
to : .
2. Press START button h.
The set value is saved.

Switching off the appliance

Short time after the end of the
programme:
1. Switch off ON/OFF switch (.
Switch off ON/OFF switch Switch off ON/OFF switch
2. Turn off the tap (not applicable if Turn off the tap (not applicable if Turn off the tap (not applicable if
Aqua-Stop fitted). Aqua-Stop fitted). Aqua-Stop fitted).
3. Remove the utensils when they have Remove the utensils when they have Remove the utensils when they have
cooled down. cooled down. cooled down.
Note Note Note
When the programme ends, leave When the programme ends, leave When the programme ends, leave
the appliance to cool down a while the appliance to cool down a while the appliance to cool down a while
before opening it. This will prevent before opening it. This will prevent before opening it. This will prevent
steam from escaping and causing long-
term damage to your built-in furniture.

Interrupting the programme

1. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
2. To continue the programme, switch
on the ON/OFF switch ( again.
en
has been
23