Automatic Switch Off / Interior Light; Switching Off The Appliance; Interrupting The Programme; Terminating The Programme - Siemens SN26T296GB Operating Instructions Manual

en
A utomatic switch off after end of
Au t o m a t i c s w i t c h o f f / i n t e r i o r l i g h t
programme or interior light*
* depending on model
To save energy, the dishwasher can be
automatically switched off 1 min or 120
min after the programme ends.
The setting can be selected from :
: .
: Appliance does not
switch off automatically.
The interior light 1"
comes on when the door is opened
irrespective of whether the ON/OFF
switch ( is switched on or off.
When the door is closed the light
is off. If the door is open for longer
than 60 min., the light switches off
automatically. The interior light 1"
is lit only when the set value :
selected.
: Appliance switches off after 1 min.
: Appliance switches off after 120
min.
– Open the door.
– Switch on ON/OFF switch (.
– Hold down programme button #
and press START button )"
until : ... is indicated on the digital
display.
– Release both buttons.
The LED for button # flashes
and the digital display 8 displays
the factory setting :
– Keep pressing programme button #
until the value : ... is indicated on the
numerical display 8.
To change the setting:
– Press programme button 3.
Each time the button is pressed,
the set value increases by one level;
when the value of :
reached, the display jumps back
to : .
– Press START button )".
The set value is saved.
– Close the door.
18
to
is
.
has been

Switching off the appliance

Short time after the end of the programme:
– Open the door.
– Switch off ON/OFF switch (.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Remove the utensils when they have
cooled down.
ã=
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.

Interrupting the programme

– Open the door.
– Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
– To continue the programme, switch on
the ON/OFF switch ( again.
– Close the door.
T erminating the programme
Te r m i n a t i n g t h e pr o g r a m m e
(Reset)
– Open the door.
– Press START button )" for
approx. 3 sec.
The numerical display 8 indicates
: .
– Close the door.
The programme sequence lasts
approx. 1 min. On the digital display
8 is indicated :
– Open the door.
– Switch off ON/OFF switch (.
– Close the door.
.