Terminating The Programme; Changing The Programme; Intensive Drying; Cleaning And Maintenance - Siemens SN... Operating Instructions Manual

en

Cleaning and maintenance

T erminating the programme
T e r m i n a t i n g t h e pr o g r a m me
(Reset)
1. Press START button h for
approx. 3 sec.
The numerical display )*
indicates :
2. The programme sequence lasts
approx. 1 min. On the digital
display )* is indicated :
3. Switch off ON/OFF switch (.

Changing the programme

When the START button h has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme
(Reset).
24
.
.

Intensive drying

The final rinse uses a higher
temperature which improves the drying
result. The running time may increase
slightly. (Caution if utensils are delicate!)
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button h until
the digital display )* : ... is
indicated.
4. Release both buttons.
The LED for button # flashes and
the digital display )* displays the
the digital display the digital display
factory setting : factory setting factory setting
5. Press programme button # until
Press programme button Press programme button
the factory set value the factory set value : the factory set value
indicated on the digital display )*.
indicated on the digital display indicated on the digital display
To change the setting, To change the setting, To change the setting,
1. Press the button 3 to switch the
1. 1. Press the button Press the button
Intensive drying on Intensive drying on Intensive drying on :
2. Press START button h.
2. 2. Press START button Press START button
The set value is saved.
Cleaning and
maintenance
e n a n c e a n d m a i n t C l e a n i n g
A regular inspection and maintenance
of your machine will help to prevent
faults. This saves time and prevents
problems.
Overall condition
of the machine
Check spray arm for grease
and limescale deposits.
If you find such deposits:
: : .
is
or off : .