Table of Contents
Advertisement
Please refer to the steps below to assist you with mounting the camera.
We suggest that you configure the camera before mounting.
Warning: Indoor use only. Do not mount in a location where it may
be in contact with water as it may damage the product and/or cause
injury.
DCS-8 0
0 L
FCC ID: KA2CS80 0LA1
IC: 4216A-CS 800LA1
3(B)
CAN ICES-3 (B)/NMB-
A1
Model: DCS-800L
Mount the Camera
30mm
36mm
Use a 6mm drill bit to drill two holes 36mm
apart, and at least 30mm deep.
Then use a mallet to insert the wall anchors
into the holes. Screw the included screws
into the wall anchors.
Place the mounting holes on the base of the
camera over the screws as shown, then slide
the camera down to mount the camera.
Make sure the camera is positioned so that
the D-Link logo is at the bottom of the base.
Adjust the angle of the camera as desired.
8
Advertisement
Table of Contents
