Conﬁguration Guide for DCS series cameras ACCESSING DEVICE CONFIGUTING INTERNET...
HOW TO ACCESS THE DEVICE:- 1. Unbox the Camera. 2. Connect the power adaptor to device and power on the device. Power LED should be RED. Connect the Ethernet cable in Ethernet Port of camera from your router. LED should be steady / stable Green.
HOW TO ACCESS THE DEVICE:- Then access camera WEB GUI using default settings. IP Address: 192.168.0.20 User Name: admin Password: blank Go to Setup > Wireless Setup III. Connection mode is Infrastructure. Click on Enable Wireless > Select Site Survey...
HOW TO ACCESS THE DEVICE:- Select your SSID from the list and click on Select. Select Wireless Security Mode same as your wireless router and then put the password/Security of your wireless router Key then click save settings. VI. You can check wireless connectivity status in the status page.
HOW TO CONFIGURE THE INTERNET:- 4. If you have the computer with wi-ﬁ then, go to wireless utility to display available Wireless networks and select the Wi-Fi name of device to connect. (By default Wi-Fi name is DLink). By default there is no security/ password for this network.
HOW TO CONFIGURE THE INTERNET:- 7. It will check for the required activex on your PC 8. Select No and click Next. 9. Click Next.
HOW TO CONFIGURE THE INTERNET:- HOW TO CONFIGURE THE INTERNET:- 10. Click Next if the connections are done as per the image. 11. If the LED is green, click Yes.
HOW TO CONFIGURE THE INTERNET:- HOW TO CONFIGURE THE INTERNET:- 12. The setup will detect the camera with the IP address. Click Next. If not detected then kindly check the connectivity and then retry. If there is no password set for camera, you have to set it when below window appears and click Next.
HOW TO CONFIGURE THE INTERNET:- HOW TO CONFIGURE THE INTERNET:- If you already have a mydlink account, then select Yes. If you don’t have, select No and register for same. If you have registered MyDlink account then put username and password.
HOW TO CONFIGURE THE INTERNET:- HOW TO CONFIGURE THE INTERNET:- This will prompt for username and password to login into the account. For ﬁrst time it will ask to update the ﬁrmware. By clicking on Update now you can update the ﬁrmware. By selecting camera you can view the video.