Table of Contents
Advertisement
Inser ting and replacing batteries
█
Inserting method
1
. Move up the switch and open the cover.
2
. Raise the battery holder and insert the battery.
Batter y
Be careful with the
battery direction.
█
Replacement method (hot swap)
e battery can be replaced without turning o the power.
1
. Hold the button
e power LED starts blinking. After a few seconds, it switches to the slow blinking
state with intervals of approximately
Hold down the button for a while.
2
. Remove the used battery.
When the hot swapping succeeds, the power LED starts blinking in
again. If the hot swapping fails, the power LED turns o .
3
. Press the button
Resume the paused application from where it is stopped.
Switch
Cover
Battery holder
❶
(the foremost button) for longer than
Power LED
en within
❶
(the foremost button).
* The manufacturing number is provided at
the inserting section of the battery (cover
section).
2
seconds.
15
seconds, insert the charged battery.
1
second.
2
-second intervals
15
Advertisement
Table of Contents
