Helion Intrusion XLR HLNA0684 Owner's Manual page 5

IKONNIK XENON HRS3.2 PROTOCOL, PAIRING AND FAIL SAFE SETTING
ing the AA batteries or rechargeable battery pack.
12. Fail Safe setting and Channel 3 toggle.
13. Beginner Mode/Feature Lock Out
14. Reset Button
Understanding Protocol and Pairing the Transmitter and Receiver:
The process of allowing communication to occur between a 2.4GHz transmitter and receiver is called "pairing" (some-
times referred to as "matching" or "binding"). The "language" used to communicate between the transmitter and the
receiver is called the "protocol". The radio system included with your product utilizes the proprietary IKONNIK Xenon (Xe)
protocol to provide fast and stable communication. The system comes pre-configured and paired from the factory. In the
event your system loses pairing, or one of the components has been replaced, you will need to pair the transmitter and
receiver. Follow the below steps for pairing your radio system. Always ensure both transmitter and receiver batteries are
fully charged or new when performing this process for best results.
NOTE: AS A SAFETY PRECAUTION, PERFORM THE PAIRING PROCESS WITH THE
VEHICLE'S WHEELS OFF THE GROUND.
1. With the transmitter in close proximity but not closer than 1ft to the receiver, turn on
the transmitter first, then the vehicle. The LED on the receiver will blink, indicating that
the receiver is not paired to a transmitter that is on.
2. Turn the transmitter OFF, hold the REV/PAIR (BIND) button and turn the power back
ON to put the transmitter into pairing mode.
3. Push the button on the receiver once, the LED will start to blink faster indicating it is
searching for a transmitter to pair with. The transmitter will automatically search for
and pair to the receiver. This may take up to 10 seconds.
4. Once the transmitter and receiver are paired together, the receiver's LED will turn solid
red. If the receiver's LED does not turn solid red, turn off both the transmitter and
receiver and repeat steps 1-2.
5. Once pairing is complete, turn the power off and back on to both the transmitter and receiver.
6. Ensure normal operation of throttle and steering.
a. If pairing to a different vehicle you may need to reverse the steering channel on your transmitter to work properly.
7. If you experience anything other than normal operation, repeat the process.
Motor
ESC
Rx
Battery
Steering
1/10th SCALE 2WD
MONSTER TRUCK
LED
Indicator
BIND
Pair
Button
Channel 4
Channel 3
Channel 2 (Throttle)
Channel 1 (Steering)
5