Installation - Kenwood TK-885 Service Manual

TK-885
Notes :
• This mode cannot be entered if the Firmware program-
ming mode is set to Disable in the Programming soft-
ware (KPG-62D).
• When programming the firmware, it is recommend to
copy the data from the floppy disk to your hard disk be-
fore update the radio firmware.
Directly copying from the floppy disk to the radio may not
work because the access speed is too slow.
6-4. Function
1. If you press the [ ] switch while "PROG 57600" is dis-
played, the version is displayed. If you press the [ ]
switch again while the version is displayed, "PROG
57600" is redisplayed.
2. If you press the [D
displayed, the display changes to "PROG 19200" to indi-
cate that the write speed is low speed (19200 bps). If
you press the [D ] switch again while "PROG 19200" is
displayed, the display changes to "PROG 38400", and
the write speed becomes the middle speed (38400 bps).
If you press the [D
is displayed, the display returns to "PROG 57600".
3. If you press the [D
played, the checksum is displayed. If you press the
[D ] switch again while the checksum is displayed, the
version is redisplayed.
Note :
Normally, write in the high-speed mode.
6
REALIGNMENT / INSTALLATION
] switch while "PROG 57600" is
] switch again while "PROG 38400"
] switch while the version is dis-

INSTALLATION

1. Accessory Connection Cable
(KCT-19 : Option)
The KCT-19 is an accessory connection cable for con-
necting external equipment. The connector has 15 pins and
the necessary signal lines are selected for use.
1-1. Installing the KCT-19 in the transceiver
1. Remove the upper and lower half of the transceiver case,
and lift the DC cord bushing (
2. Remove the pad as shown in Figure 1 (
3. Insert the KCT-19 cable (
The wire harness band (
4. Replace the DC cord bushing (
5. Connect the KCT-19 to the TX-RX unit (A/2) as shown in
Figure 2 ( ).
7
6. Connect the KCT-19 to the external accessory by insert-
ing the crimp terminal (
both of which are supplied with the KCT-19.
D
B
CN4
E CN1 B
CN2
CN3
B
C
CN6
6
7
1 ) from the chassis.
).
2
3 ) into the chassis (
) must be inside the chassis.
5
6 ).
) into the square plug (
8
1
2
Fig. 1
E
C
D
5
4
9
3
A
13
15
Crimp terminal
(E23-0613-05)
Fig. 2
).
4
),
9
Square plug
(E09-1571-05)
1
3
Contact
8