Realignment - Kenwood TK-885 Service Manual

TK-885
C key (Default setting : None)
9
Press to activate its auxiliary function below. Also press
to scroll left while viewing stack entries.
D key (Default setting : None)
10
Press to activate its auxiliary function below. Also press
to scroll right while viewing stack entries.
CALL key
11
Press to call the displayed call address.
• Display
displays the strength of received signals, the output
power (high or low), status numbers, and received call
types.
appears when a control channel is found. It flashes
while the transceiver is searching for a control channel.
flashes when you activate call diversion.
appears while there is data in the stack. It flashes when
there is new data in the stack.
displays call addresses, the call dura-
tion timer, data messages, and the current operating status
of the transceiver.
1-3. Conventional Mode
• Key functions
The numbers correspond to the Figure 1.
Transmit/Receive indicator
2
Lights red while transmitting.
Lights green while receiving a signal.
/ (Control) keys
4
Press these keys to select your desired channel.
key
6
Press to return to Trunking mode.
A key
7
Press to turn Scan ON (or OFF).
B key
8
Press to add/remove channels to/from Scan.
CALL key
11
Press to turn the squelch OFF in order to monitor your
selected channel.
• Display (Refer to Figure 2)
displays the strength of received signals.
appears while you are monitoring a channel by press-
ing the CALL key.
appears while you are scanning.
4 current operating status of the transceiver.
OPERATING FEATURES / REALIGNMENT
Fig. 2
displays channel numbers and the

REALIGNMENT

1. Modes
User mode
Panel test mode Panel tuning mode
PC mode
Firmware program-
ming mode
Mode
User mode For normal use.
Panel test mode Used by the dealer to check the funda-
ment characteristics.
Panel tuning mode Used by the dealer to tune the radio.
PC mode Used for communication between the
radio and PC (IBM compatible).
Data programming Used to read and write frequency data
mode and other features to and from the radio.
PC test mode Used to check the radio using the PC.
This feature is included in the FPU.
See panel tuning.
Firmware program- Used when changing the main program
ming mode of the flash memory.
2. How to Enter Each Mode
Mode
User mode
Panel test mode
PC mode
Panel tuning mode
Firmware programming mode
3. Panel Test Mode
Setting method refer to ADJUSTMENT.
4. Panel Tuning Mode
Setting method refer to ADJUSTMENT.
Data program-
ming mode
PC test mode
PC tuning mode
Function
Operation
Power ON
[B]+Power ON
Received commands from PC
[Panel test mode]+[A]
[A]+Power ON