External Speaker - Kenwood TK-885 Service Manual

TK-885
2. Fold the flat cable (
3. Rotate the control section (
4. Insert the flat cable into the control section connector,
CN502 ( 5 ).
5. Mount the control section on the transceiver (
2
3
4
6. Rotate the control panel 180 degrees and mount it on the
transceiver. Refit the two halves of the case to complete
installation. (Fig. 14)
12
INSTALLATION
) in the opposite direction (
1
) 180 degrees (
3 4
6
6
1
CN502
5
Fig. 13
Fig. 14
).
2

8. External Speaker

).
8-1. KES-3 : Option
The KES-3 is an external speaker for the 3.5-mm-diam-
eter speaker jack.
).
• Connection procedure
1. Connect the KES-3 to the 3.5-mm-diameter speaker jack
on the rear of the transceiver.
8-2. KES-4 : Option
The KES-4 is an external speaker used with the acces-
sory connection cable.
• Connection procedure
1. Install the KCT-19 in the transceiver. (See the KCT-19
section.)
2. Insert the crimp terminal into the square plug supplied
with the KCT-19.
3. Connect CN5 of the transceiver to connector C of the
KCT-19 instead of to the internal speaker connector.
1
3
13
6
15
12
Crimp terminal
(E23-0613-05)
Fig. 15
Black lead
Black/White lead
Fig. 16
KES-3
KES-4