DeWalt DW088 Original Instructions Manual page 63

in bright light conditions or over long distances. The detector can be used
in both indoor and outdoor situations where it is difficult to see the laser
beam.
The detector is designed exclusively for use with the DW088 and the
DW089 line lasers and other compatible D
use with rotating lasers.
The detector gives both visual signals through the LCD display window (17)
and audio signals through the speaker (18) to indicate the location of the
laser beam.
The D WALT Digital Laser Detector can be used with or without the
E
detector clamp. When used with the clamp, the detector can be positioned
on a grade rod, leveling pole, stud or post.
Batteries (fig. F)
The digital laser detector is powered by a 9-volt battery. To install the
battery provided, lift up on the battery compartment cover (19). Place the
9-volt battery in the compartment, aligning the battery as shown on the
embossed icon.
Detector Controls (fig. F)
The detector is controlled by the power button (21) and the volume button
(22).
When the power button is pushed once, the detector is turned on. The top
of the sensor window shows the ON icon and the volume icon.
The D WALT Digital Laser Detector also has an auto shut-off feature. If a
E
laser beam does not strike the beam detection window, or if no buttons are
pressed, the detector will shut itself off in about 5 minutes.
To turn off the audible signal push the button again; the volume icon will
disappear.
The detector powers up in the narrow accuracy setting (icon appears in the
lower left corner). Press the accuracy button (23) once to change to wide
accuracy setting (icon now appears in the lower right corner).
Accuracy
The detector provides two accuracy settings, wide and narrow. In the
wide setting, the detector provides a larger tolerance for indicating that the
E N G L I S H
WALT line lasers. It is not for
E
61