Advertisement
W
iring diagram
Fig. D-2
Lead wire to Spark plug has to be pulled
out by 70 up to 75mm from the opening
of Handle set (R).
When putting the following
lead wires into lead wire holders,
do not cross them in this area.
* lead wire (red) to DC motor
* lead wire (black) to DC motor
* lead wire (white) to Switch unit
for DC motor
* lead wire (black) to Switch unit
for DC motor
Put sag of Connecting lead wire
to Spark plug in this position.
Wind lead wires (red and black) to Line filter one time,
passing them through Line filter. And connect them to
connector of DC Motor.
Fig. D-3
Lead wire to Spark plug has to be put
on the other lead wires viewed from
Top cover side.
Put Connector and sag of
lead wires in this position.
Earth terminal
Wiring in Handle set (R)
Connector to
DC motor
Line filter
Spark unit
Pay attention not to put
lead wires on the rib in
this area.
Line filter
Wiring on Cylinder head
Connector
70 up to 75 mm
boss
rib
Switch unit for DC motor
Connector
Terminal
Fix lead wires (yellow, black) of
Spark unit with these lead wire
holders without putting sags.
Facing the wire connecting portion to plus mark side,
connect Flag receptacle to Minus terminal.
Wire connecting portion
Straight receptacle
Pass DC motor's lead wires (red, black)
through the notch of the rib for setting
DC Motor.
DC motor
Spark plug
P 16/ 16
Put lead wire (black) of
Spark plug between rib
and boss.
Put lead wires (black, red)
for DC motor between
Switch unit and boss.
Switch unit for trigger
Put lead wires
into lead wire
holders.
Flag
receptacle
Terminal
Advertisement
