Makita GN900 Instruction Manual
Cordless clipped head framing nailer
Hide thumbs
Also See for GN900:
- Instruction manual (77 pages) ,
- Instruction manuals (64 pages) ,
- Instruction manual (57 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Makita GN900
Summary of Contents for Makita GN900
- Page 1 INSTRUCTION MANUAL Cordless Clipped Head Framing Nailer GN900 Read before use.
-
Page 2: Specifications
SPECIFICATIONS Model GN900 Nail length X Shank diameter Nail L :50 mm - 90 mm d : 2.9 mm - 3.3 mm Nail capacity 40 nails (1strip) Nail collation angle (degree) Figure of nail head Clipped Dimensions (L X W X H) -
Page 3: Ec Declaration Of Conformity
when loading and unloading, as the fasteners WARNING: The vibration emission during actual have sharp points which could cause injury. use of the power tool can differ from the declared 12. Always check the tool before use for broken, emission value depending on the ways in which the misconnected or worn parts. - Page 4 qualified health professional regarding overall operator. activities. Be careful with tools without workpiece con- tact as they can be fired unintentionally and The continuous use of the tool may cause repetitive strain injury due to recoil produced injure operator and/or bystander. by the tool.
- Page 5 Make sure all safety systems are in working Additional safety instructions for gas tools order before operation. The tool must not oper- Use the tool only with the Makita genuine gas ate if only the trigger is pulled or if only the contact container.
-
Page 6: Functional Description
MISUSE or failure to follow the safety causing fires, personal injury and damage. It will rules stated in this instruction manual may cause also void the Makita warranty for the Makita tool and serious personal injury. charger. Tips for maintaining maximum... -
Page 7: Installing Or Removing Battery Cartridge
Installing or removing battery Fuel cell cartridge Attaching the metering valve to the fuel cell • Always switch off the tool before insertion or removal of the battery cartridge. ► 1. Metering valve 2. Cap • To remove the battery cartridge, withdraw it from the tool while pressing the button on the side of Detach the cap (in case the metering valve is provided the cartridge as shown in the figure. -
Page 8: Adjusting The Nailing Depth
Blinking orange after blinking green and red alter- nately: Fault detection is running. Remove and reinsert the battery cartridge to reset. If fault detection is running again, it is malfunction condition. Ask your local Makita service center to repair it. 8 ENGLISH... -
Page 9: Loading The Nailer
Installing the hook Pull the Pusher Lever to the rear of the Magazine and return it to the end of the strip gently. ► 1. Hook The hook is convenient for hanging the tool temporarily. The hook can be set in two positions according to where the tool will be hung. -
Page 10: Operation
► 1. Trigger OPERATION Hold the contact element pressing firmly and pull the trigger. WARNING: Fuel gas is combusted and the nail is driven. • Do not touch around the exhaust vent. The Further driving can be initiated only after both the surface will be so hot during or after an oper- contact element and the trigger are released. -
Page 11: Maintenance
Maintenance after daily work • These accessories or attachments are recom- mended for use with your Makita tool specified Always check the tool for its overall condition and loose in this manual. The use of any other accessories screws before operation. Tighten as required. - Page 12 Makita Corporation 3-11-8, Sumiyoshi-cho, Anjo, Aichi 446-8502 Japan 884862G228 20190112 www.makita.com...