Maintaining The Automatic Ice Maker - Mitsubishi Electric mr-z65r Operating Instructions Manual

Table of Contents

Advertisement

Maintaining the Automatic
Ice Maker
Cleaning once a month
Pull out the water supply pipe.
Wipe the tank holder with clean cloth.
Do not let water flow into the tank holder.
Or else, it may cause malfunction.
Separate pieces and wash with water.
Twist on the aluminum pipe to replace it.
*The water supply pipe may be white due to
minerals or chlorine, but this is not abnormal.
Wash the pipe and continue using it.
Reverse the steps to replace the pipe
Replace the water supply pipe. Make sure
that sides A and B fit flush against each other.
Otherwise, the ice maker may malfunction if
the pipe is not installed properly.
Make sure that no foreign
object is found between
the water supply pipe and
the pipe junction.
Improper fitting or any foreign
object will produce a clearance
between the pipe and the pipe
junction to cause freezing of the
water tank.
Cleaning once a month
Cleaning the ice tray using water from the water tank
Remove ice from the ice storage bin and
close the ice making compartment door.
Fill the water tank with water and set it in place.
Press
The display (
(for
about 1 minute
(The ice tray will be cleaned by the water from the water tank.)
Repeat step
Remove the ice storage bin and
discard the water and ice.
Do not discard the two-layer soundproof mat.
22
Water supply pipe / Tank holder
Water
supply pipe
To be
horizontal
Water tank
Tank holder
(On the
refrigerator
body)
Ice tray (Rinse it with water)
on the control panel and
hold for about 5 seconds.
(Until the buzzer emits "peep, peep" tone.)
,
,
, or
)of the ice making compartment will blink
).
2 to 3 times.
Aluminum
pipe
Packing
Water
supply
Side A
pipe
Side B
Pipe junction
Pipe
Be careful not
to pinch any
foreign object.
Water
supply pipe
Remove
ice
Ice storage
bin
Tank
holder
Cleaning once a week
Water tank
Remove the lid and wash
with water.
(the tank can withstand up
to approximately 60°C)
*If the water tank is prone to get moldy
due to the nature of water, clean the
water tank 2 to 3 times a week.
Be sure to read all instructions for
detergents, bleach and other
cleaning products you use to clean
the water tank and lid.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents