Mitsubishi Electric mr-z65r Operating Instructions Manual page 26

Table of Contents

Advertisement

What to do when...
when
Electric power
goes out
To move the
refrigerator or to
change the direction
The unit will not
be used for a long
period of time
Transporting
the unit
To set the freezer
to low temperature
freezing
All indicators blink 3 times in a constant
interval even though no button has been
pressed. Or, the compartment display
and temperature control display on the
control panel blink in turn repetitively.
(In the demonstration operation mode)
If
mark is blinking rapidly
(about 5 times per second)
Or if the alarm cannot be turned off.
26
Lift adjustable supports. Remove the leg covers.
Move it in forward and backward directions
Make sure to place a cloth for floor protection underneath the caster and rear support before changing directions.
Clean the automatic ice maker.
After removing the power plug from the outlet, clean the interior of the unit. Leave the
doors open for 2 to 3 days to sufficiently dry the interior of the unit.
*
Discard the water and ice in the water tank and the ice tray.
Wear the protector such as work-gloves.
Remove the leg cover and lift up the adjustable support.
Pull out the power supply plug.
Place towels beneath the exhaust port and at the corner
beneath the back side of the refrigerator and then place a
container or a tray about 3cm high to collect water.
Slowly tilt by about 30 degrees towards the rear and drain water collected
in the evaporating dish from the exhaust port located at the bottom of
the rear side. (The evaporating dish is not visible from outside.)
*
Gently transport the unit with 4 or more people, gripping the hand-
holds on the lower-front interior and the upper-rear of the unit.
Warning
It uses flammable refrigerant, do not damage the refrigerant circuit. If the gas leaks, ignition or explosion may be caused.
Press
repeatedly until the
Press
and
simultaneously for about
3 seconds. (until the buzzer emits "peep, peep" tone.)
Press
to set the temperature control to
Set the temperature control display to any level other than
To cancel
*
How to cancel demonstration operation
Keep the refrigerator door open.
Press
Press
Check that display lamps stop blinking in 1 minute.
Contact the retail store at which you purchased it
or MITSUBISHI SERVICE CENTER
Follow the instructions below
22
page
lamp lights up.
two times.
,
and
7
page
21
page
Exhaust port
Front Lower
interior
Front Lower interior
.
or follow step
simultaneously for about 5 seconds.
Upper part of
back side
The "FZR"
lamp blinks
about every
10 seconds.
above.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents