Serial T1/E1 Probe Settings
Table 3 Serial T1/E1 probe settings
Setting
WAN/Frame Relay Type
Encapsulation
Fractionalized
Bandwidth
36
Configuring Observer for your WAN device
Chapter 2 Installing Your GigaStor
Table 3 describes fields for a serial T1/E1 connection.
Explanation
Choose T1 or E1 to match the type of link you are analyzing.
You must set this to match the settings on the frame relay router.
Check if your link is configured for fractionalized operation.
Set to match the bandwidth setting of the link you are analyzing.
rev. 1