Connecting Observer to the GigaStor
Redirecting the GigaStor probe
Figure 5 Remote Probe Administration and Redirection
22
Connecting Observer to the GigaStor
Chapter 2 Installing Your GigaStor
This section assumes you have already installed Observer on your
desktop or laptop. If not, install the software. You can download from
the Network Instruments website.
There are three main tasks to connect Observer to your GigaStor
"Redirecting the GigaStor probe" on page 22
"Probe administration" on page 24
"GigaStor Capture Analysis" on page 29
Choose Start → All Programs → Observer → Observer. Observer
1
opens.
Select Actions → Redirect Probe (Figure 5).
2
Click New to add the GigaStor to the Probe Administration and
3
Redirection list. Figure 6 appears.
rev. 1