Table of Contents
Advertisement
Configuring Observer for your WAN device
rev. 1
Figure 20 ToS/QoS tab
There are a number of setup options and statistical displays unique to
WAN Observer, which are described in the following subsections.
Before you can analyze the WAN link, you must set some device
options. You must also have the appropriate administrative privileges
to change WAN device settings.
"Digital DS3/E3/HSSI Probe Settings" on page 34
"Digital T1/E1 Probe Settings" on page 35
"Serial T1/E1 Probe Settings" on page 36
After configuring your connection, you should begin using Observer
to monitor your connections. To get started, use the information in
"Using Observer with a WAN Probe" on page 79.
Configuring Observer for your WAN device
Chapter 2 Installing Your GigaStor
33
Advertisement
Table of Contents
