System Test - Honeywell PRO TH3210D Manual

Installation Guide
Follow tile procedure below to test tile heating and cooling system.
System test System status
number
1System switch
1 Set SYSTEMswitch to Heat.
2 Press W to turn on and check systems (see table, below).
3 Press V until systems turn off.
4 Set SYSTEMswitch to Em Heat and repeat steps 2-3 above.
5 Set SYSTEMswitch to Cool and repeat steps 2-3 above.
5 Press and hold _V'A to terminate test at any time.
System Test
System Status
10 Heating system
20 Emergency heat
30 Cooling system
70 Thermostat
information
(for reference only)
0 Compressor and fan turn off.
1 Compressor and fan turn on.
2 Auxiliary heat turns on.
0 Heat and fan turn off.
1 Heat and fan turn on.
2 Auxiliary heat turns on.
0 Compressor and fan turn off.
1 Compressor and fan turn on.
71 Software revision number (major revisions)
72 Software revision number (minor revisions)
73 Configuration identification code (major)
74 Configuration identification code (minor)
75 Production configuration date code (week)
76 Production configuration date code (year)
CAUTION: EQUIPMENT DAMAGE HAZARD
Compressor protection (minimum off time) is bypassed during testing. To prevent
equipment damage, avoid cycling the compressor quickly.